Jump to content

Tequila

Members
  • Content Count

    11
  • Joined

  • Last visited

Community Reputation

0 Neutral

About Tequila

  • Rank
    Newbie
  1. Thankyou for your advice and suggestions. The motor and sensor cable is £24 is this reasonable for the product?
  2. Just found this one, do you think this will work with everything we discussed? http://m.ebay.co.uk/itm/221871317542
  3. So aslong as I remember to connect them to the corresponding ones I should be fine? I thought I had to buy a specific colour of wire for each one haha
  4. Ok thankyou and how do I know which wire is the correct one to connect to from the motor because I remember certain ones have to connect to a certain colour from the motor?
  5. The blue orange yellow wires from the esc aren't long enough to reach all the way to the back where the motor is. Could I buy the wires you suggested to extend all 3 so it will reach and then solder it all together? I found this on Amazon, would it work the same as the one you suggested? http://www.amazon.co.uk/Foxnovo-Gauge-Flexible-Silicone-Battery/dp/B00RE0X56U
  6. Does it come with the wires?
  7. Ok thanks but where are the coloured cables that plug in?
  8. Thankyou Is brushed motors just as good as brushless? I've been looking at this? 540 Motor Brushed 12 Turn Designed to work with 12 turn ESCs or above. Specifications: 12x2 turns 32.000 rpm 165 watt 7.2 - 7.4 volt Size 540 Shaft length: 12,3mm Shaft Ø 3,18mm Motor length 53,2mm Motor Ø 35,7 mm Part Number: 2310072 Made by: Absima
  9. Would this be ok with a technigold 540 or any brushless sensored motor? And what is the best oneI could get? http://www.amazon.co.uk/Electric-Upgrade-Parts-Steel-Pinion/dp/B00PZSF6D8
  10. The esc has 3 different coloured cables coming off it. I only use 2 to connect to the motor and the other one is left
  11. I just setup my neofighter kit (the frog) and I've been reading up on brushless motors a lot recently. My esc says it is brushless compatible but requires you to set it up for brushless? Also how would I install a brushless motor and would I need to buy a new tooth thing? I have a 17t one currently. Sorry for not being able to explain in detail as I'm still learning.
×
×
  • Create New...