Jump to content

new2race

Members
  • Content Count

    6
  • Joined

  • Last visited

Community Reputation

0 Neutral

About new2race

  • Rank
    Newbie
  1. Hello, I am interested in the Plasma Edge. Please let me know how we can proceed. I live in Miami. Regards, Francisco
  2. Dear Greg, Thank you very much for your comment. I actually liked the set with both front and rear tower: http://www.junfac.com/shop/index.php?main_...products_id=436 Cheers!
  3. Excellent job! I recently bought a Vintage Frog and was thinking of converting it into a Baja Bug project and you just gave me the heads up! Where did you find the front shock tower and the rear suspension arm? How did you have the Bug body installed on the chassis? Congrats once again!
  4. Dear all, Thank you very much for the replies. I replaced the pinion for the original one and also decided to buy a heatsink to help the motor with some heat transfer. I had ball bearings and a new ball differential to prevent transmission problems. Now, I do have another question, what do you think could be the lowest motor I could use for this model? Regards,
  5. Dear all, I was reading this topic and would like to make a question. I recently bought a Vintage Frog with no body and would like to buy a Sand Scorcher body to match the chassis. Does anybody know what I would need to add/replace in order to fit it? Thank you in advance!
  6. Dear all, I was reviewing the different forums and was not able to find an answer to my problem. Here is the issue: I recently upgraded my ESC to a Duratrax Motorsport 8t and added a Super Stock Motor TZ (23t) to my DT-02 chassis (Sand Viper). I am running a ball differential with a 19 tooth pinion gear. I can run the motor for 10 minutes until it stops completely. When I checked the motor, I can feel it is very hot and actually the ESC is running very cool, so this is not an ESC overcurrent/overheating problem. I believe there might be an overheat circuit preventing the motor to keep running. Can anyone suggest how to cool the engine without modifying the heat protection? Thank you in advance!
  7. Hello, I had the same problem until I noticed the setup diagram on the ESC. If you notice the connections on the ESC, you might be missing the Battery connector. Nowhere is indicated how the polarity goes, but you can safely connect it aligning the black cables (negative) and then proceed with the setup. Hope this helps!
×
×
  • Create New...