KEV THE REV

Sorted now - parts for these are hard to find !!

Does it need to be separated?. In the past I have separated parts like this by dropping the long shaft end into an open vice set to the shaft width but with a 'fag paper' of slack , then drift out the shaft by tapping the short end of the shaft downwards. If the shaft is resistant you can use a long socket or tube over the long shaft end and a insert into a vice horizontally to 'press' the shaft short end to get a start then drift the rest out

Has anyone got a cheap TR15T truck roll bar for sale / swap - used for a runner - UK only please Thanks

Sorted now . Back in stock on eBay from TTP

I switched from 27AM to 2.4g and bought the Absima set you mention . It is a good basic set up and I like it . I bought a few more Fly-sky FS-GR3E receivers ( they are the same as Absima as I believe Absima is a rebranded Fly-sky ) and paired them to the handset so I can use different cars with the same handset. The receivers are much smaller than the old 27 receivers and can fit into a chassis very easily and don't have all the old ariel wire trailing all over the place

Thanks for the reply . I saw those on Tamico , but I'd rather wait for UK stock and I'm not in a rush

Thanks Si. , All good here , looks like you're having fun over there mate

Hi all . Has anyone got a G parts tree F&R body mounts for the Stadium.Blitzer / Stadium Thunder . Good used parts will also work UK only please Thanks

We're all behind you 👍. Look foreward to seeing the progress

Incredible work , looks excellent

Outstanding work as always 👍

Thanks a lot mate , I might give it a blast when the weather improves and I get some time . I've run it indoors to test but it keeps laying down rubber tracks on the floors and I get a thick ear from the misses 👎

More pics of damper tops bolt through and turnbuckles

😎

Thanks guys , yes all good , haven't been involved a lot of late , not had a lot of free time . Hope you're ok too. I've got more pics to add later