svenb

I've a 1:64 decal sheet which I'd like to up to 1:10 for a project. My idea is to up scale it and print on paper to see if it works out then if ok transfer to printing. Anyone with any experience in this type of stuff?

1400SCR battery in box or just the box 1600 LiFe battery Possibly a TB Evo 5ms That's it😉

Day or should I say night of scrapping off under seal🙁 nasty nasty job

Just looked 👍🏻

@GToddC5 you are being watched 🧐

Have to admit to looking forward to seeing a capital G in a red circle ( @GToddC5) in the The "Postman brought me" thread. You my friend are on an absolute mission! There can't be many Tamiya models you don't have by now 😂

Here you go Glass tape apparently 🤔

I've the 53261 sat in my spares box, I can dig it out and photo the instructions for you!? You strap the battery in with tape.

@Wooders28 is that a Pontiac I see?

It's not a rotisserie just a dolly, it's great though especially when it's bolted down. I do have a rotisserie but not using it yet as the chassis section at the front needs some repair.

Bought a car dolly to make a bit more workable. More I do on this less I'm tinkering with Tamiya!!

I've seen the Capri before but not the rapid Cortina 😯

It would I agree but unfortunately the wallet says no! It's a completely rebuilt engine so I'll run that first. I do keep my eye out for 4.6 , they are a bit prone to liner lift . Would need a top hat job.

Yes , vitesse block with fast road cam , big valve heads and Edelbrock carb.