KEV THE REV

The best polish out there

Hi all . I'm looking for a front 'gearbox' half or both halves . This isn't actually a gearbox but merely a servo housing . I need the RH side as viewed from the drivers seat ( LH as viewed from the front ) UK only please. Thanks.

I've got a Sport Tuned in it with 15T Steel pinion , it does burn-outs in my conservatory much to my other half"s dismay - nothing that a bit of cleaner can"t remove - the skid marks that is , not the other half

I just edited my previous answer - but I used the stock discs and it all might need tuning to accommodate the rear end weight

I stripped and rebuilt them with new O rings and the stock disc etc and from memory I used red oil but I haven't run it in anger 👍

Thanks Simon . I checked my spares boxes for the SRB rims that I was sure I had , but no luck , glad you got that sorted too .

Sorted now - parts for these are hard to find !!

Does it need to be separated?. In the past I have separated parts like this by dropping the long shaft end into an open vice set to the shaft width but with a 'fag paper' of slack , then drift out the shaft by tapping the short end of the shaft downwards. If the shaft is resistant you can use a long socket or tube over the long shaft end and a insert into a vice horizontally to 'press' the shaft short end to get a start then drift the rest out

Has anyone got a cheap TR15T truck roll bar for sale / swap - used for a runner - UK only please Thanks

Sorted now . Back in stock on eBay from TTP

I switched from 27AM to 2.4g and bought the Absima set you mention . It is a good basic set up and I like it . I bought a few more Fly-sky FS-GR3E receivers ( they are the same as Absima as I believe Absima is a rebranded Fly-sky ) and paired them to the handset so I can use different cars with the same handset. The receivers are much smaller than the old 27 receivers and can fit into a chassis very easily and don't have all the old ariel wire trailing all over the place

Thanks for the reply . I saw those on Tamico , but I'd rather wait for UK stock and I'm not in a rush

Thanks Si. , All good here , looks like you're having fun over there mate

Hi all . Has anyone got a G parts tree F&R body mounts for the Stadium.Blitzer / Stadium Thunder . Good used parts will also work UK only please Thanks

We're all behind you 👍. Look foreward to seeing the progress