CoolHands

Kind of

Hi Marwan, thanks! I only ask as I’m interested. I’ve previously purchased optima tyres from you. I once looked into getting Marui Big Bear tyres made but the metal mould cost was too high. I wondered if there was another way.

Don’t have a nib gazoo TS050 going do you?

Took my Dynahead out for its maiden run. Bit naughty as I haven’t finished my decaling yet as I’m customising it

I find I spend as much time admiring my progress as doing the actual decaling!

I wish he would tell us how he gets them made. Does he have a proper metal mould made for injection moulding or what

I don’t have an flysky but I think this is the adjust you need to do. Skip to about 4 mins and reduce your steering endpoints

I cut my Dynahead body out (just realised I only have photo of before I cut it!)

I like the lights how did you get the fluorescent yellow look on the lenses ? Is it paint?

Maybe put a wanted ad on a few Facebook rc groups?

.

Check you correctly used parts 16 and 17 for the rear arms if using 4WS. They have the single line as opposed to 2 so easy to check see pic

I had a super clod buster, then sold it. I think I’m going to get another one!

Everyone’s modelling and stickering skills seem to be moving up a notch lately

Ghostpig where’d you get the spacers etc from? Do you have a link? Eg the 3x6x2 etc