svenb

The dampers or the dickie bird? My lad hand reared him from a week old chick after he was rejected, he has the whole house for myself! The damper cylinders cost less than buying stuff for Frank 🙄

Thanks @yogi-bear I actually could understand that😅 Tomorrow evening I'll(wife) have a go scanning and see what happens, fingers crossed. If I can get the templates for the main stripes that would help.

Swapping out the TRF damper cylinders for some HL jobbies and titanium coated rods. Frankie finch is helping

Very jazzy 👍🏻

Good news but what's 600DPI 🤔😅

My mistake, the decals I have are 1:24

I have got the slot car version, one of the reasons for wanting it on a RC.

Unfortunately not, it's the 1400SCR I'm after. Thanks for the thought though 👍🏻

We have a scanner apparently, again a job for the good lady 🙄

That's the one, lovely isn't it

I'll ask the wife👍🏻

Here's a photo of it, small and probably difficult to copy. It's the larger areas which are more important. I'm hopeless at anything computer! This forum ,eBay and emails on my phone is about my limit. I have tried MCI racing and had several emails back and forth but almost 2 years of waiting and nothing, don't think he wants to know🙄 fair enough I suppose ,Nathaniel does some nice stuff and he's done a bit for me before this must be too minor for him.

I've a 1:64 decal sheet which I'd like to up to 1:10 for a project. My idea is to up scale it and print on paper to see if it works out then if ok transfer to printing. Anyone with any experience in this type of stuff?

1400SCR battery in box or just the box 1600 LiFe battery Possibly a TB Evo 5ms That's it😉