Jump to content

lesgrandepotato

Members
  • Content Count

    9
  • Joined

  • Last visited

Community Reputation

3 Neutral

About lesgrandepotato

  • Rank
    Newbie

Recent Profile Visitors

361 profile views
  1. My lads cc01 and hotshot have an issue. You can adjust the servo trim with the controller and the servo moves. So the radio can send to the servo it appears. However using the wheel has no effect. So I stripped the controller, I’ve got continuity from the pot to the board and the pot is changing resistance. So the board must be duff on the steering channel?
  2. Got GT tuned motor and bearings in mine. Goes well and it’ll wheelie hard off the line like that.
  3. I’ve got some servo on axle kits on order for my lad and my clod. We have a 3 channel radio so I’d like to use the third channel to switch between 4wheel steer and crab. Does anyone know of a cheap solution or a circuit design to achieve this?
  4. It is, but it’s flat red, not a deeper cherryish metallic that I have in my minds eye
  5. I’ve got a couple of Lipos I use in vaterra trucks. I’ve got a problem i think, but I don’t understand it. Yesterday I charged the batteries and put them in the Twin hammers ( a rock racer with a 15t motor ) and it immediately cuts out and the buggy won’t run. so today we took both out in an ascender for a crawl. After 2hrs of crawling the battery was still at 7.5v - albeit the ascender has an 85t motor not a 15. Why would there be such a difference between the two models, other than the motor turns they run the same esc?
  6. Looking good! I’m just about to do mine in mica red metallic as a change from the box art
  7. We’ve had a super shot for sometime, we have just built a hotshot to race against it. It’s sufficiently different to make it a worthwhile build along side in my view. The linkage suspensions being particularly pleasing to build.
×
×
  • Create New...