Lund Moon Visor - Powered Up!!
Status: Extra info
Date: 15-Feb-2009
Comments: 4
After a couple of redesigns of the wiring layout, I managed to simplify it enough to complete 80% of the wiring with just the led leads, leaving just the power feeds & one jumper each to make it all work.
The leds will be fed from a constant current source, this means no series resistors are necessary.Drive current will probably be set at about 25-30mA to give good brightness, the photos below were at 20mA & while they look pretty good, I feel they need just a little more ''OOMPH''.
The leds are standard 2mm x 5mm yellow & wired in parallel. I know parallel wiring is never recommended, but as these leds are pretty well matched there is no discernable variation in brightness between them.
Just a few quick photos to give you an idea of how it looks.
Comments welcome as always.
If you liked those pictures, you should see these...
Lift ^Lux Work In Progress, Part IV
Comments
Old Skool
I am liking it more and more Great job
MvT
Nice, pity that such details are not made by tamiya, but on the other hand it keeps us nicely busy with our own ideas very curious when it is finished!
ranger blue
looks great, top job
def4x4
Looks good that idea which the leds. Great job and like to see if your truck is finished!
Want to leave a comment?