Wreelybro

I will do I need to start a Thread for them as well. Here are two that are 95% finished

Nice job. I've just restored a Cheetah too, shows they're still out there.

Freshly restored Cheetah and Leopard A4

Hello Tom, yes interested in the decals if you have some spare. If you search eBay for the following I used just the lenses.: 2* LED Spotlight Headlight Roof Light For Axial TRX4 SCX10 1/10 1/8 RC Crawler

That was an option I had considered if my 3d prints don't come out as planned. I think a 3mm will fit, I've got loads kicking about too..

Was an e-bay special - I'll have a look through my purchases see if I can find it.

Thanks I enjoyed doing it. These are some replacement lenses I found which fitted perfectly with a small bit of fettling. The original are sadly too far gone to use. (Kept them though)

This is what it was like before I started:

This is my 98% completed restoration - hope you all like it. This is my first full respray using a model airbrush there was a lot of learning along the way but I'm happy with the final results. I'm just short of the Red front indicator/marker lights and the Decals. (If anyone on here has these spare I would be interested. - Long shot but always worth asking) I've still got the Driver to paint up but not sure if I want to have him in the model.

Thanks for the info I've now gone with box art livery I may do one of the 5 x XR311's I have with Zebra scheme though

Yes I tend to agree with you.

Which netting you think looks better the smaller or the larger?

Restored the lights front and rear also aded some detail on the winch and the rear mesh resprayed and installed. I am missing one side of the red marking lights on the front I'm going to see if I can resin print some replacements