misamae

Thanks a lot for your comprehensive advice. Your initial suggestion was right. The problem was in the gearbox. I installed the gear attached to the motor in the wrong way. Now I'm reassemblying the box. Thanks mate.

that seems to be a lot of work at this stage. Do you know if there is any other way around it?

I've just installed the MFC-01 unit on my scania r470. But when I move the left stick on the remote, I hear some noise but the truck doesn't move. Any advice? Thanks, Mesiam.

Thanks a lot for your help. The servos are working fine now. But I got a new problem: The steering rod touches the fender!!!

Which cables? from servos to MFC or from MFC to the receiver? I've just tried to adjust the MFC unit. after I press SW1 button on the MFC unit the light on the control panel starts to blink and it does not stop. That means I cannot continue with adjusting the unit.

Thanks for your reply. I'm assemblying scania r470. What is MFU?

Hi, I've attached my servos to my MFC01 unit. But when I switch on the device from the control panel servos start to rotate without any command from the transmitter. Any advice? Thanks, Meisam.

Thanks a lot.

I trimmed it more and now it fits in. Just needed to make sure this is an appropriate way to do it.

I trimmed one of the plugs but it still does not fit. I think the mcf unit plug is wider

Hey all, I'm assemblying tamiya scania r470. Unfortunately my mfc01 unit receiver cables does not fit into my receiver. Does any one know a way around this issue? Thanks, Meisam.