hobbyteam

I got this https://www.lrp.cc/en/products/charging-equipment/accessories/produkt/multi-balancer-adapterboard-xh/details/ balance board for the Pulsar. The small cables that comes with the board and are used to connect the balance board to the charger have from 4 to 7 cables. Which one of them should i use to charge a three cell Lipo or a two cell lipo battery pack? Thank you in advance, regards Tassos.

Hi, back with a question... i set the power supply to 13.8V and the charger at 2A to charge a nimh pack. the display of the power supply shows from 1A to 1.2A does that mean the battery is being charged at that current or at the one set on the charger? Am i doing something wrong? thank you in advance, regards Tassos.

Thank you both for the help.

Hello everyone, just got the LRP Pulsar Touch charger. I need a power supply to use it. The charger's input is 11V-15V and the charger's power is 140Watts. I am looking to get the Fusion 200W Adjustable Power Supply which has adjustable output 5V-15V and is 200Watts. Will it work with the charger? I think it will but i am new with the batteries... thank you, regards Tassos.

Thank you 94eg. I will try it and hopefully everything will go ok I will let you know.

Hi there, Thank you for the detailed description. sorry for the late reply, been for hollidays with the family. When you say the bit to face down, it should look like the pics you posted on the post #6 of this topic? Also the corner of the bit should be on the center or above of the comm and not the whole bit, right? Thanks.

Thank you!

Hi everyone, silicon wires are marked with a number and the letters"AWG" for example 10AWG wire. Could somebody explain what that means and what the different marks are used for? Thank you.

94eg, thank you very much that was more than helpful. I already ordered the Integy V-block, just like yours. greetings from Greece.

Thank you all that was very helpful. But because it will be the first time i will use a comm lathe what is the difference between a Vblock and a bearing comm lathe?

I am looking to get a comm lathe. Any suggestions? Thank you.

Thanks for the replies, how can i measyre the voltege while the bettery is in use?

Hello, is there a way to determine if a battery pack is fully charged or needs re-charging using a multimeter? For example in a 7.2 Ni-Mh pack wich is the voltage that shows that the pack needs re-charging? Also is the voltage enough or there is a way to measure the amps? Thank you.

is the SMD capasitor used to prevent RF noise and radio interference?

So zero point will at the mark in the middle between the + and - marks?