9zapp

not recommended really as if you go to low you can reverse the polarity' quite easy if you forget about the bulb being connected' best to get a cycler/charger rather than damage your cells

Has anyone actually got 1 yet? see them on the bay just pondering over 1

Hi there, just fitted my Ezrun 9t and was thinking of trying 3s Lipo this weekend now to run power to the 5v fan' you have to cut the red and black or desolder the terminals and connect a futaba plug and into the receiver or a separate battery that's how I understand it? it which is better idea separate battery or plug straight into the receiver? wouldent you have thought EZrun would have just limited the power to the fan to 5v instead of all this messing about

yeh Thanks for that TA- Mark just ordered a load of pinions after reading on here' have decided to upgrade all models to steel bin the alloy

Hi there, can anyone tell what the correct pinion size is for this model' the old alloy one I took of has 14 teeth is this correct ? there is no manual on the Tamiya site to download and check...

nice one never ticked that "option box" before and it has brought up 3 sellers now instead of one for the same thing' I'm glad Rcboyz sell these pinions as i point blank refuse to buy of my_atomic although tower hobbies and stormer hobbies stock them and there good to post to the uk. I think tower was 8 dollars to send me 12 pinions which is very good

modelsport seem to have a nice selection of the RW .6 pinions in stock think i will a couple while they have them in stock' also order from tower hobbies RR pinions at £2.00 each grabbed a dozen diff ones

can get these local....Not used RW before'which is the correct RW pinion size RW .6 pinion or RW 48DP pinion? I cant seem to source any more of the RR pinions at the moment only on ebay via seller atomic which after you buy he loads you on delivery charges

thanks Mark I thought as much about the pinion ...just looking for some washers now:)

Hi there, Just built a new M03 but the drive shafts /stub axles seem to have lots of play is this normal? about 1mm of float..Is it best to space shim them up and which side between the bearing and hex drive or go for the inside hub/bearing? also is it ok to use the stock pinion or is it better to get a robinson racing one

thanks a lot will give it a go..

you mean by shims the disk springs?2x 4mm and 2x5mm concave looking washers no shims came with the kit..

Hi there, just assembled my TA03 ball diff but on adjusting it managed to strip the nut/bolt only useing a box spanner and it diden't feel that tight is this just me being to heavy handed or is it a problem with this diff ? or maybe i should have gone for the more sturdy but cheaper manta ray diff its for a new m03 mini build is it worth the hassle or just stick with the bevel diff ?

which ones would you recommend?

any one sin particular i see the 53192 tamiya ones is that just the same as what i have already