Danielson

Well I thought I would post a little update.. I am still waiting for my alloy wheel hex's and kingpins to arrive from Asiatees.. So no pics of those fitted.. But I have fitted new turnbuckles. Now the car is looking so nice with the new gearbox cases and alloy parts fitted, I have decided that I dont wanna use it anymore.. So its back to being a shelf queen. I will look for another chassis to fit my electrics in.. Something a little more up to date I think.

http://cgi.ebay.co.uk/ws/eBayISAPI.dll?Vie...em=300578354279

http://cgi.ebay.co.uk/ws/eBayISAPI.dll?Vie...=STRK:MESELX:IT http://cgi.ebay.co.uk/TAMIYA-TA02-FRONT-C-...=item45fb5558e1

Nice work indeed.

Hi peeps, got the above on ebay. http://cgi.ebay.co.uk/ws/eBayISAPI.dll?Vie...=STRK:MESELX:IT Cheers, Dan.

Looking good! Nice to see another clean TA02

So I got the new gear cases fitted, had the car completely apart and cleaned every piece.. I think it's looking pretty well now. I ordered a pack of 3x10mm (black) screws of ebay as a few are now looking a little shabby.. Hopefully the wheel hex's and Alloy C hubs will be here next week.. Next purchase will be the alloy rear Knuckles and the rear ARB kit, maybe some adj rear upper arms and universal front driveshafts too.. It seems I have well and truely been bitten by the bug again. Cheers, Dan.

Just got a great deal on a set of Top Force A and B parts, will be here tomorrow.

Nice one, thanks for the info guys!! I finally got my alloy knuckles today and fitted those. Very nice quality, so I ordered the C hubs and lightweight king pins too. Hopefully get a chance to run the car at the wkend.

Hi peeps!! I would like to buy the black/grey gear cases. Can someone tell me what other cars use these. Ive seen some for Top Force/Manta ray etc.. Not sure if they are the same? I am aware that the Ford F150 uses the same as TA01/02.. Cheers in advance, Dan.

Very nice.. swap the rear tyres over though.. you got them the wrong way

Hi Craig.. I havent ran it as yet, I did hold the car and give it a blip.. Might be a little quieter than it was, but its hard to say tbh. Cheers, Dan.

The drive shaft came today, and I just fitted it.. Did you use the O rings? As it seems very tight with those in place, So I left them out for now.. I noticed that the cup where the driveshaft fits in was catching ever so slightly on the front gear case, so I took a blade to it and trimmed it a bit. I should be ready for Lipo power now.

Any suggestions on what charger?

Got it on order, was hard not to get carried away and order loads of bits.