thebigwig

Thanks!

Hi, I am having problems with this chassis. I have a Durga and was planning to replace the stock chassis with this new carbon chassis. But here's my problem => I have stripped 10 screws when putting the front and rear differential covers. two of the screws broke. I noticed that the screws were very hot while I was tighten by hand. So am I supposed to use a different type of screws? I have already messed up one carbon chassis and don't want to mess up again with the second carbon chassis. Please advise. Thanks

Awesome! Thanks for the explanation. It helped a lot! cheers

Looking to get a slipper clutch set for my db01. There are 2 options here and just wanted to know what's the difference (beside the price) and is one better than the other. First Option => RC DB01 Double Slipper - Clutch Set (#54061) Second Option => RC Slipper Clutch Set (#54018) I am using DB01 Aluminum One-Piece 18T Pulley and it says that it should be used with #54018. Wonder if this will work with #54061? cheers

@ speedy_w_beans => Thanks for pointing out the twisted arrow! I was able to reverse the bolt without having to disassemble the entire gear box! Crazy.. haha. I need to watch out for these twisted arrows... They are twisted alright! cheers

You're right, I do see the twisted arrow now. Thanks. Question now is can I remove the bolt and flip to shorter diff joint without disassemble the entire rear and front gear box?

Hi, I run into a problem with the durga differential assembly. According to the manual, the long bolt goes through from the longer diff joint and the spring goes into the shorter diff joint and then you tighten it. I did all that but now when I assemble the rear drive shaft, it barely goes into the short diff joint because the spring, K4 and bolt is not all the way in. so should I flip it around and put the bolt through the shorter diff joint since the longer diff joint has plenty of room? Is the the instruction in the manual wrong? Please advise. Thanks

Wow, that's expensive!

OK, I see it now. It's a replica made by *****. But it doesn't come with under tray. Can I use the Egress under tray? I also see original body set. I bet the final bid price will be outrageous. I like avante 2001 but not that much if price is too high Thanks

There's nothing there when I clicked on the linked?? Thanks

Awesome! Now all I have to do is find the re-release Avante 2001 body. Do you thin tamiya usa has this body or it is probably discontinued? Thanks again!

Thanks!

Hi all, I have a question regarding to the Avante 2001. It looks like the Avante 2001 shares the exact same chassis as the Egress 2013? Is this correct? Will the Avante 2001 body fit on Egress 2013 chassis? Does the Avante 2001 uses the same under tray as the other Avante 1988 & 2011? I like the look of Avante 2001 and I just build Egress 2013 so I wonder if I can interchange the body? Thanks

Awesome thanks mate! cheers

Hi, I just purchased a brand new clear Baldre body set from ebay for my Durga chassis. I don't know the paint colors that I need to purchase to paint the body per manual. I have searched everywhere on the interent for the Baldre manual but with no luck. Would someone please point me in the right direct for the manual? Or if you can post the portion of the manual that shows the tamiya paint color code? Many Thanks