Jump to content

VeyronEB

Members
  • Content Count

    13
  • Joined

  • Last visited

Community Reputation

0 Neutral

About VeyronEB

  • Rank
    Newbie
  • Birthday May 12

Contact Methods

  • ICQ
    0
  • Yahoo
    driver_231@yahoo.com

Profile Information

  • Location
    Ireland

Recent Profile Visitors

854 profile views
  1. Give her enough wine and she'll soon forget.
  2. New Bright 1/10 hardbody RC body shell. Its 1/10 a Mercedes SLR body shell would be good for a tamiya or similar chassis. Its in good condition has some small wear on the rear bumper where the shine has come off. It has quite a few removable parts lights, grills, etc. Great condition shell. Check it out here
  3. Thanks for the suggestions, had my first (minor) glitch today, the rear suspension screw loosend until it was completely out causing it to drop at the back. That's stones for ya. Luckily nothings broken Though ive noticed its very hard to keep debris from going inside the shell
  4. Thanks for the help I have ordered a new steel pinion. A SteelMOD 0.6 16T to be exact. Where is the best place to find parts like roof racks, wheels and body shells?
  5. Bit of a bump here, but anyhow I bought a receiver from ebay and got it working well but it was crunching alot. So I later found that it was the AV pinion that was lose so I tightened it up and its working perfectly. Here it is, the colour doesn't show up very well on this camera. Thanks a ton for your help.
  6. Yes my radio is also 27, and the crystals are correct.
  7. Ok, then thanks for your help I'll get another receiver. Either of these two: Opps, Sorry if I broke any rules with posting live auctions
  8. No it defiantly is a BEC receiver, its says so on the front of it.
  9. Went through a few threads and found this post http://www.tamiyaclub.com/forum/index.php?...rt=#entry435488 Tried the battery pack with the steering servo in CH2 and it didn't work, but was fine in CH1.
  10. Ok, I've tried everything you've suggested and still no luck what so ever...
  11. Yes i've acctually went through a few crystals, about 6... Thanks for you help Dave I got the low voltage cut-off off and got it to flash once at the start but I still can't set it up and it won't double flash, really frustrating.
  12. The batteries work fine and there new and full charged, and the steering servo works and it turns the steering but the motor won't setup.
  13. Yeah I defiantly have got all the plugs in correctly and sure its wired correctly. Yeah and I have got instructions for the esc.
  14. Hello, I have just got new a Tamiya CC-01 chassis Toyota Land cruiser, about 2 months ago and it came with a Ranger ii N controller, receiver and servos. After building and wiring it I went to do the ESC setup (TEU-104BK ESC) but the matter what I do I can't seen to get past the first step, and if I plug the motor in I get a beeping sound and nothing else. There's a 27.195 mhz AM RX crystal in the receiver and a 27.195 mhz AM TX in the controller. Thanks for your help. And sorry if this is a stupidly n00bish question.
×
×
  • Create New...