Jump to content

TheGarfather

Members
  • Content Count

    38
  • Joined

  • Last visited

Everything posted by TheGarfather

  1. All the parts for the differential.
  2. So after some more thinking and drawing I realized I had to make a new and longer endplate for the differential. Same material as before. Two 10x15x4 bearings that supports the secondary outdrives that has two 5x8x2.5 bearings supporting the primary outdrives, a 5mm shaft I made out of 7075-T5 aluminum.
  3. So, decided to build a 1/10 rally car with a center differential and belts instead of shaft. Did some thinking and drawing and ended up with this. Based on a Xray XB4 high volume differential. Put the diff case in the lathe and removed the bottom. Made a new out of 6082-T6 aluminum. Used a diff cross pin from Xray X1 so the bevel gear axle could run through the differential. The concept worked. 😁
  4. Yes, sorted and I'm a bit ashamed to be honest 😑🙃
  5. Nevermind, I'm feel so stupid right now 🙁
  6. What car are these from? They were in the 51454 bag along with the standard TA06 front bulkhead and bits. The rear shock tower from my TA06 Pro fits, so it must be a rear bulkhead. But the front differential does not fit. So confused.
  7. What are the softest springs available for the aeration dampers? Including non-Tamiya
  8. I live in Sweden and with shipping, customs and sales tax they will become insanely expensive. That's why I'm looking for scans so I can have them printed locally.
  9. I'm about to restore these three cars and the lexan bodies are fine apart from the decals that are dry and cracked. Buying original ones is impossible. Where can I find high resolution scans so I can print my own?
  10. Need front and rear swingshafts from a XV01 PRO. As cheap as possible 🙄🙃
  11. If I'm using the 19mm Gmade hex adaptor with the Mad Bull rear rims, would it increase the track width?
×
×
  • Create New...