jah1610

Hi, Apologies if this is a stupid question. I've just purchased a FlySky FS-i6S TX as I was after a stick transmitter that can be used with multiple vintage cars. Can anyone recommend what RX's to use with this? Can I use any FlySky branded RX? Thanks

Hi, I’m looking for some some advice. I’m currently In the process of upgrading my 10 year olds TT02B as he want’s more speed & better handling. I’m not looking to spend a fortune as this is only used for bashing over the park etc. The car is currently stock with the exception of a 15T HPI Firebolt Motor. The upgrades i have purchased so far are - Full Turnbuckle set Alloy motor mount Alloy prop shaft & joints Alloy steering assembly. Full rubber bearing ballrace set. A few questions I have - Is the high gear set worthwhile. What size pinion would you all recommend. looking for some larger wheels/tyres to increase ground clearance & give improved off road performance. Thanks.

Hi, can anyone recommend a good 2.4ghz stick transmitter (reasonable priced) that I can bind up to 5no RX's to. Thanks

Hi, I'm after a chassis for a striker restoration if anyone can help? Thanks

Hi, I'm looking for an original Striker manual. Can anyone help? Thanks

I'm in Colchester Essex..

Right I've tried again this evening... I've now got the ESC in the correct mode (brushed). I've checked & the rx is getting a signal from the transmitter (tried it in another car with a MSC). Following the instructions for high point set up the led flashes red-green-orange-red when I release the set button on the red the LED starts to flash a single green & not Red as per the instructions. if I then keep following the instructions the LED doesn't go off. I've followed the set up instructions & it just will not set up. I'm at a loss & as I'm a newbie am I doing something wrong? any help advice greatly received....

I've now got the ESC in the correct mode (brushed). I've checked & the rx is getting a signal from the transmitter (tried it in another car with a MSC). When plugged into the ESC how do I check it's getting power? I've followed the set up instructions & it just will not set up. I'm at a loss & as I'm a newbie am I doing something wrong? Is this rx compatible with this ESC.

After building my son a TT02b (Neo Scorcher) I really liked the ESC that came with it (TBLE-02s) so i decided as I was currently overhauling my M-03 Mini I would upgrade to one. This evening I plugged it all in (I'm using an old Acoms BEC receiver AR-227FE & an Acoms servo AS-7). The ESC either flashes red or green. I cant seem to set it up. On the TT02b it was a simple 2 min job. Is the acoms receiver/servo compatible with this ESC & if so any pointers on what I'm doing wrong. Thanks in advance...