SNIPEOverkill

Thank you kurt will have a look. Who is sharpeways?. Photos will follow at some point but build still has a little way to go before it’s ready for a photo shoot

Does anyone know if there is a company who produces inner door panel mouldings for the scania.

They are spec’d the same as the s3003 and S3004 for voltage usage. It is a direct replacement for the S3003. Fingers crossed

Got two on order here Tuesday hopefully got the P-SU300 as that is knee the replacement for the s3003.

Think I’m going to swap out the servos, been having a look the s3004 are a little expensive the s3003 is cheaper and the only difference seems to me the s3003 has ball bearings and the s3004 is brushless the voltages Look the same. Would I be right in saying that.

Thank you for the reply TF. What is a good low voltage servo and what sort of voltage should I be looking at, as most likely going to swap mine out.

What you are mentioning here timatc sounds like what I am trying to sort out on my Scania build which is fitted the mfc 3 fitted, my issue is with the programming it never seems to fully program indicators work from time to time the horn sound changes etc also it will not stay in 1st gear will only stay in 2nd and drops out of 3rd from time to time it’s becoming very frustrating as I’m so close to finishing the project. have a radio link t8fb 8 channel which coemwith the kit when I purchased it so I was under the impression that it would be fine with the mfc. I don’t know if it’s me doing something stupid I have followed the instructions word for word. Could it be I have a servo issue that’s causing this. I was wonder if I should purchase the futaba 4ywd transmitter as the instructions mention it as compatible. Any help will be greatly appreciated.

Ok thank you

Pant help out there

Sorry been about for a while what with work moving and the general daily grind not had much time for the truck. my Truck is the Tamiya Scania r620 and if it is fitted with the mfc 03 unit. I have been having trouble getting all the functions to work and stay working. but got it back out again tonight and I have a question I have had trouble setting up the lights and sound just so happens today one of my jobs was out a model shop so I asked the bloke inside and he said I should get the futaba attack 4ywd 2.4g transmitter. Question I have what I have seen of the futaba is it is only 4 channel would this allow me to have all the light and sounds working and any added lights to work. My current one as pictured above is 8 channel. Any help would be appreciated trying to get pasted this issue so I can finally get it finished and lacquered. Then it’son to the trailers.