Chatweka

I did a factory reset of the transmitter and reinstalled the firmware update again, bound the flysky 10 channel and 6 channel receivers to the transmitter with no trouble, must have been a gremlin in the system somewhere and scared it off with the reset

thanks TurnipJF found the mix screen and it is off, Ive only got this problem with the flysky receiver my turnigy receiver doesnt have this issue and its exactly the same just branded with a different name.

Hi I have a Flysky fs-i6s transmitter with a ia10b receiver and when I use channel six weather by switch, button or stick, channel seven also operates but when channel seven gets used only that channel works. Any help on fixes would be much appreciated thank you.

I have the fs i6s with my Freightliner Cascadia which even though it says i6s its a 10 channel but comes with a 6 channel receiver

So I’m still building but I hooked up the gear box servo and can get it to change gears by using one of the 3 position switches after a bit of reprogramming so I’m thinking with a bit of kafluffing around with the programmable bits I might get it to do what I want

Thanks I will be getting a mfc, probably the mfc03, but that’s a while away yet so I’ve ordered a 540 brushless 4370kv with a 45A esc for $45 aud, thought I’d get a combo then they should be matched

Looking for what Esc to get for my Cascadia truck. I’m using 7.2v 5000mah battery and the standard 540 motor. Even an idea on resonably priced motor and esc combo would be appreciated. Thanks

Thanks have seen this and it is good but mine is the S version

I’m looking at using my Flysky fsi6s remote from my wrecked drone. Will it work fully with Freightliner Cascadia and mfc03b