Frh076

Members
  • Content Count

    45
  • Joined

  • Last visited

Community Reputation

2 Neutral

About Frh076

  • Rank
    Newbie

Recent Profile Visitors

151 profile views
  1. Frh076

    Slash 4x4 heat on 3s.

    What about the 2400kv castle motor and the hobbywing or mamba esc?
  2. Frh076

    Slash 4x4 heat on 3s.

    The high speed gearing is not fitted, but I have read that the velineon system is not good for 3s, so I wa t to upgrade it
  3. Frh076

    Slash 4x4 heat on 3s.

    I'm in Norway. But the problem is not that the veleneon is bad, it's just that I want something better- perhaps a 1/8 motor.
  4. Frh076

    Slash 4x4 heat on 3s.

    On 2s it is fine, but I want to drive it on 3s
  5. Frh076

    Slash 4x4 heat on 3s.

    Does love kv give more speed in that case? I drive it on asphalt or on gravel, it becomes hot on both.
  6. Frh076

    Slash 4x4 heat on 3s.

    I don't want to use 6s. I want to use 3s, perhaps 4s but unlikely, without it being warm. By hot I mean that the plastic on top of the esc is melted.
  7. Frh076

    Slash 4x4 heat on 3s.

    The motor and car is well maintained. It has fans, and I have low gearing. The heat comes after about 5 minutes, and I am wondering what I can do to prevent by buying a new motor.
  8. Are there any cheap motors that I can fit into my slash to make it run cool on 3s? Should it have low kv -what are the drawbacks of this? And should it be capable of running ex 6s- will this make it cooler on 3s than something that is limited to 3s?
  9. Frh076

    Colt gt1 Porsche

    Sorry, should have specified. Meant the body shell only.
  10. Is the Porsche gt1 from colt good? I mean, is the quality bad, and is it made from thin plastic?
  11. Frh076

    Hard rc bodies

    Which brands have thick plastic rc shells for 1/10 cars? Im looking for tamiya-like stiffness, and I don't want the sort of soft bodies from ex hpi.
  12. Frh076

    Speed aerodynamics

    The chassis is the 4tec 2.0 vxl, with castle "something" kv motor. I know the car is 1cm too wide for the body, but I had this body left after a flip over (le mans-style crash, almost burning through the roof at 100kmh that is why I attached the front cardboard).
  13. Frh076

    Speed aerodynamics

    Yeah. I also have made the front less steep, and have reduced the air under the car from putting a piece of thick paper(?) To almost rub against the ground. It works very fine. However, want to know if this or a similar sort of mod on the rear can get my car to hit somewhere around 100mph.
  14. Frh076

    Speed aerodynamics

    Would this design increase the top speed of the car, or should i do something else/ change it? I took inspiration from the McLaren speedtail.
  15. Frh076

    Vacuum forming rc bodies

    I still want to vacuum form. I just have a problem of not finding any cheap material in Norway. The only thing I have found costs 400$ for 2x3 meter