Jump to content

Tedtf

Members
  • Content Count

    5
  • Joined

  • Last visited

Community Reputation

0 Neutral

About Tedtf

  • Rank
    Newbie

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. What length of the yeah racing - 50 or 55mm? And Shock Gear or Qutus version?
  2. One more question. If I use a torqued tuned 540 motor and the 68t spur gear, what pinion gear should I use on the motor? 17T i assume will give most speed? I have 16t thru 21t gears. Thanks
  3. Not too deep. I was thinking propeller shaft, alum propeller joints, alum motor mount, alum steering bridge, alum racing steering, torque tuned or gt 540 motor(i think it has to be 25t motor to work with speed control ). Fast Eddys bearing kit. Thanks
  4. I have built a few Tamiya off road cars. Latest was the plasma edge 2. But have not built on road. Was thinking about the Ford GT MKII kit and wanted to see if anyone had any build experience with it? And or recommendations on key hop up parts. Thanks
  5. I just found my old Tamiya Hornet in a box in the garage and it has renewed my interest in building R/C again. I purchased a Plasma Edge II and am considering a bunch of hop up parts for it, but not sure what I "need". Any advice is appreciated. Not looking to go brushless at this time. Sealed bearing kit Tamiya 53068 Sport tuned motor Tamiya 54556 and 54557 - Front and rear damper stay set. I also considered the Yeah Racing Aluminum essentials kit. i think these would be redundant if I buy Yeah kit? ?? Tamiya 54501 Aluminum drive shaft Tamiya 54574 Aluminum racing steering Tamiya 54575 Aluminum steering bridge Tamiya 54558 Aluminum motor mount Tamiya 54815 (OP1815) TT-02B Reinforced Gear Cover & Lower Suspension Arms - I think these would be redundant if I buy Yeah racing kit. ??? Tamiya 54539 RC TT02B FULL TURNBUCKLE SET 95mm and 70mm alumnium adjustable spring dampers. I think these are made by gpm
×
×
  • Create New...