Muddipete79

I have attached some photos from the manual, I can't see anything that refers to type of glow plug. My HPI one died in 2 min. So I have a cheap Chinese one which seems ok. I have the factory set for needles, remember to turn high needle in i think 1/4 turn once broken in. As the manual states. I run 25% nitro. Set factory, then slightly adjust the idle needle I have found this helps to get more fuel in. I also pump the fuel in a good 6-7 pumps. Hope it helps.

I have found original manual. I'll check for glow plug info

So started today after around 30 sec. Not run for 2 years. Used HPI glow plug. HPI lube in each hole. Removed and replaced pull starter. Set up to instructions using 25 percent nitro. Good luck

Wish could help out, I am a total novice in nitro engines. Good luck

Try that, should be full manual without tuning ndf01.pdf

Cheers mate, that was quick. Amazing.

Added off-road springs and oil, foam filled buggy tyres and wheels, change gearing for wheels. Going to run it for a while, then fully strip, clean and upgrade. Will be project for my son 10 also.

You are a legend, thanks so much.

Hi, Recently re-built NDF01 Nitro Force I have had for a while. Unfortunately I have lost the manual with the base engine tuning settings. I have looked online for hours and cannot find any. I did find the Nitro thunder manual, but this does not contain the engine tuning. Thanks