RallyX

I've been doing some variation of this livery since last year. Didn't realize at first that it's the retro Toyota color scheme, but that just means that my rally and GT Pro Spec cars will just have to be Toyotas from now on (once I inevitably destroy the Ford GT MkII body).

I picked up a Citroen DS body, and it came with dogbones to widen the track width of an MB-01 in front to match the real car. Anyone have any notions for how I might do that on the XM-01?

I picked up a Citroen DS body for my XM-01, and the instructions say to use the included hubs and dogbones in front because the full scale car has a wider track in front than in the rear. Problem is that those parts are for the MB-01, and nowhere in the paperwork or that I can find on the website is it listed how much wider the front track is than the rear. I figure I might be able to use wheels with an offset in the front, but I don't know how much of an offset I'm looking for. Anyone have a way to get the correct measurements?

I've never seen the option part sheets on the Tamiya website! I generally go to the page for the chassis and click the link to spare parts or option parts, and currently the link to option parts is blank.

I figure that the least they could do is publish a list of which parts it has in common with the XV-02.

I think we should petition Schumacher to make M-Chassis SST Mini Pins. That's what I've been using on my XV-02 and they're perfect for the dirt track I run on. I'd love to get the same grip from my XM-01.

My 6000mah racing packs with bullets fit fine, as well as my Protek rounded lipo, because both cables are near the center. None of my other hardcase lipos fit due to the cables being at the corners, not do my packs with a higher capacity.

My unobtainium springs have arrived from Hong Kong.

Anyone find a heatsink that fits? I just ran mine with a Sport Tuned motor with a 28t pinion and the motor is hot enough to burn. Though to be fair I think my gear mesh is too tight.

Do you think the XV-01 Stabilizer Set would fit on the XM-01?

I don't know about dimensions, but I can tell you that my Lectron Pro batteries don't fit because the cables are on the corners. My rounded ProTek battery with the cables in the center fits fine, as do both of my racing packs with bullets.

Finally had the chance to run my XM-01 on a dirt track yesterday, and the rear end was a bit looser than I'd like. Do any of you have a source for softer springs that will fit these mini shocks? I'm in the US, but I don't have a problem with ordering from overseas.

What lipos are you guys running? Mine is almost done but I noticed that my Lectron Pro 2s won't work because there's no room for the balance cable.

Mine arrived at the shop on Monday here in Michigan.

Are you still running the stock plastic steering parts? Everybody around me who got one broke the steering parts in the first week or two.