HellHoundOne

Thank you good sir. The bearing sizes are spot on. I ordered the ones for the main gear, and a full set. I found that in the full set there was four in the gearboxes I could use. So instead of ordering four, I just buy all new ones and swap some of the old ones too. I discovered I am missing one grub screw. So now on a hunt for that. The rest of the bearing should be in today. Rwd for now 🤣 I have not decided what engine I wanna toss in it yet. An O.S. Fs26 would look amazing in there. But so hard to come by…. I do have a fs12, toki 15, cvr 12-15, and a 15ld. The ld would have to be on the mounts, and not sure that would look properly.

So I started building this. And I have discovered that there are needed bearings. Or they are missing. I don’t know. Do any of you happen to know the sizes? The steering are four and the main shaft gear looks like two. I went out to a bearing shop, but they didn’t have anything that fits. Thinking on this now, I am going to look in the gearbox and see if any fit.

Found a MRE kit on eBay. Might have even been one of you guy’s kit. After I bought the kit, I picked up a TA01 roller. I have been struggling the last few weeks, I didn’t wanna open the kit 🤣. Anyways….