[The XM-01 fanbase or general info on this new pro chassis 58738]

On 12/1/2024 at 12:42 AM, Alex97 said:

The XM01 is overly generous when it comes to mourning your ESC and RX so I had to get creative 🤣

 

I've also fitted standard M chassis shocks to lower the ride height, it's now around 6mm front and rear. 

 

 

Anywhere we can get a shorty lipo adapter like that? 

[The XM-01 fanbase or general info on this new pro chassis 58738]

Thanks! I’ll pick up a set of those for sure. Last thing I need is a wheel bouncing down the parking lot 😄

[Tamiya XM-01 Pro Build]

On 6/16/2024 at 12:55 PM, chris.alex said:

Thanks for the build thread! When assembling my XM01 I also noticed a difference in the amount of slop between left and right, but only a very small one (0.1mm) and at the front only. 

I too have noticed this. Before I found this forum, I thought I incorrectly assembled something. I spent 30mins going back and forth. Shimmed with 0.1mm front and rear on one side each to solve this. 
 

On both your builds, did you find the rear axle shaft too short with the 1mm (6mm total) hex spacer? The locknuts won’t even thread into the nylock portions. 

[The XM-01 fanbase or general info on this new pro chassis 58738]

I just finished building my XM01, but find the wheel axle shafts too short. If I run the 1mm spacer in the rear as suggested by Tamiya, the wheel nut will not thread up to the nylock portion. Has anyone else had this problem? 
 

Thank You!