Rens040

Thanks for the tip guy's. I will order a set of RB5 / Dirt master steering arms for sure to test it out. My initial test also did work... kind of. I ordered a set of 12mm hex convertors for Tamiya and measured the included bearings, 5x8x2.5. Ideally i would need 4x8x2.5 bearings but couldn't find them yet. What i could find and ordered where 4x8x3 bearings, so 0.5 thicker than needed. As of now this doesn't seem to be an issue as nothing is binding.

Hello all, I converted my Tomahawk to "turbo" Tomahawk specs. ( long wheelbase, wider front axle, Turbo Scorpion wing, 2.2 wheels etc ) Now i wanted to have a wider range of wheel selection. On the rear axle i already have the 12mm hex adapters from Turbo Scorpion. I would like to have also 12mm hex on the front axle. The only conversions i could find are the 5mm axle to Hex conversions. But Kyosho uses 4mm axles on these cars. I did already order a set to see if i can find bearings with the same outer dimensions but with smaller inner. Or... does anyone know of a readily available 4mm axle to 12mm hex conversion for these cars?