Search the Community
Showing results for tags 'adapter'.
Found 1 result
Kalameja posted a topic in Vintage Tamiya DiscussionSo I've been running my old Futaba 70mhz transmitter and receiver with a new Tble-02 ESC. I've been getting tons of interference with the transmitter and receiver so the car will speed off at times. Either there is inference between the ESC and transmitter or there is just too much noise out there in the neighborhood with all the other frequencies bouncing around out there Probably time to upgrade to. 2.4GhZ transmitter and receiver. So for my education would you all give some suggestions for a good set up for a new 2.4ghz radio? I'm sorta partial to Futaba but only because that's what I've always had. I'm open to new manufactures. I plan on build another Hornet and probably a Sand Scorcher or Super Champ so they will be getting new 2.4ghz radios for sure. So whatever suggestions you all have that would be helpful thanks! One other concern, I have several original Futaba servos that are in perfect working condition that I could reuse in my new builds. The issues however is that they are so old they have the original 3 pin male connector at the end. I see that all new receivers, ESCs, and servos now have the 3 pin connection reversed. The receiver is now the male and all that connect to it have the female end. Would someone suggest an adapter? Or just purchase new servos? I did find an adapter that allowed me to us the new Tble-02 ESC with the old Futaba receiver but I don't think that connector will fit into a new receiver? Or will it? Pictures attached.