Search the Community
Showing results for tags 'battery flysky imax'.
Found 1 result
Hi TC Guru's I need a little advice. Was given a Flysky GT3B without paperwork. Can someone advise what VCC on the receiver is used for and if I can run my motor cooling fan from Ch3 or where I'm best to wire / splice connect it? I've purchased a few Turnigy 5300mah nanotech lipos and an Imax B6ac. This is my first time using Lipo's. There's so much advice on various forums I've achieved paralysis by analysis. I welcome any tips but also have the following questions as the battery came without paperwork or a manual and the imax manual seems a bit vague. 1. What state does the battery come in? Charged, discharged and or what is a storage charge? That seems obvious, storage that is but do I need to apply a storage charge between weekend use? or what period would require a storage charge? 2. Do I have to check balance before charge / discharge? 3. What is an appropriate voltage cut-off for this type of battery? again ive read from 2.8 to 3.4v? Guys I'm sure for seasoned users of Lipo this all seems rudimentary but given the cost of lipos and how relatively easy its seems (after more reading) to destroy them I want to ensure I'm doing the right thing. Any suggestions on correct settings for this lipo and any hints, tips, tricks for using the Imax B6ac would be great also. Fox + Nova Fox, both running Turnigy 5300 nano's, speed passion 3500K brushless and reventon S with motor cooling.