Search the Community
Showing results for tags 'modifying chassi'.
Found 1 result
-
Hloo! I really like the Sand scorcher body. I really like the CC-01 chassi. Combine the two i wanted. Guggle has surprisingly few hits on how to do it...what was needed to be done to the chassis. Found one on a scale-rc forum that makes the body sit really well. However, the modification made the use of the usual cc01 bodies more difficult since the back body post holes were cut away. I wanted to eat the cake and still have it. So I began to cut and test and cut some more (rinse and repeat) until i finally found what i think was a good compromise. ---------- How the body sits: The cuts I made: On the last picture where you can see ..uhm... heated plastic glue residue(from a gluegun) I'm going to put a strip of velcro to fasten the Sand Scorcher body when the body is finished. And then I made new removable body mounts with computer screws and steering links so I can use my other cc01 bodies. Yes, the plastic has been damaged after some rolls and flips...it still holds the mounting screws though. I might need to make new somewhere else, but if you drive somewhat more sensible than me, this could be a nice solution i think. Yes.. that was my contribution... Hope someone can use it! =)
- 2 replies
-
- 2
-
- cc-01
- modifying chassi
-
(and 1 more)
Tagged with: