Search the Community
Showing results for tags 'super hot shot'.
Found 1 result
Currently building a re re Super Hot Shot and chose the hobbywing 1060 esc for its built in LIPO fail safe and a few other things it odes better than the stock esc in the kit. When installing though the power switch has a really short lead and doesn't seem to reach the on off switch location on the super hot shot body, which I presume is the same location as for the hot shot, for those that may have installed in a hot shot. Also in the kit we're meant to place screws down through the body via pre-drilled holes, into the switch. The 1060's pre-wired switch is smaller than the stock Tamiya one and doesn't have holes to receive these screws. With that said, what's the recommended mounting solution for the power switch ? Currently I have it temporarily serve taped under the access panel, which is a pain as I have to take the body off each time to turn the car on. Any ideas or examples greatly appreciated.