Polycarbonate body weathering

[Blista]

I was thinking of using TS46 Light Sand spray on the outside of a rally body to give it a dusty appearance.  Anyone done that before or something similar?

I figure a few light passes across the front, some heavier arcs after each wheel, and then a bit on the rear.  Spray the outside face of the wheels and maybe tape off the windscreen to simulate the wipers cleaning it.

[KEV THE REV]

On 4/18/2022 at 5:22 AM, Blista said:

I was thinking of using TS46 Light Sand spray on the outside of a rally body to give it a dusty appearance.  Anyone done that before or something similar?

I figure a few light passes across the front, some heavier arcs after each wheel, and then a bit on the rear.  Spray the outside face of the wheels and maybe tape off the windscreen to simulate the wipers cleaning it.

I'm interested in replies , I'd like to try this 

[alvinlwh]

Straight out of the can will probably be too heavy. Decant the paint and use an airbrush will work. 

[Willy iine]

I too would use airbrush and acrylic just in case one screws up and need to remove it.