Mercedes-Benz CLK-GTR on TC-01 Chassis

[svenb 4267]

I don't have an answer for a TC-01 but the IFS I've built on a TA05/6 and TB03 will not fully fit the whole threaded section of a 5mm ball connector in. The manuals had the aluminium spacers used 

[Old_Corny 320]

Spent a few minutes finishing of the front upper cover, exchanging the kit balls for the coated ones with hex screws as recommended here:

[skom25 2210]

Remember that Hard Hex ball connectors are lower than standard connectors. To achieve exactly the same position of connector, you need to add 1 mm spacer.

[TurnipJF 10282]

However the fluorine coated alloy ball nuts used here are the same dimensions as the stock ball studs, so the stock geometry is maintained with no need for spacers. 

[skom25 2210]

2 minutes ago, TurnipJF said:

However the fluorine coated alloy ball nuts used here are the same dimensions as the stock ball studs, so the stock geometry is maintained with no need for spacers. 

Argh!

I am blind. I read Hex Connectors instead of Hex Screws.

Sorry!

[TurnipJF 10282]

Any progress to report? Or is your back preventing it?