ford f350 hi lift

[BigBison]

hi chaps which 2.2 wheels  and tyres fit f 350 hi lift ? cheers paul

[mymonsterbeetleisbroken]

Most 2.2 wheels can be made to fit the high lift. Look for 12mm hexed wheels first ( and always choose a pair of rear wheels)

You should be able to fit larger hexed wheels with the correct size hex adapters too.

As for tyres, you are limited to any low profile ones unless you lift the body higher on the chassis. Otherwise the tyres will rub on the shell and the truck will look odd aswell.

I've lifted my truck using a lift kit available on ebay uk. I'm currently using thunder tiger wheels (as i had them laying around) but i'm after a set of aluminium beadlocks at the moment. My tyres are HPI Yokohama Geolandars.

This wheel and tyre combination wouldnt work without the 15mm body lift kit though, as the tyres would rub the shell as the suspension moves. With the lift kit, the tyres work perfectly. [H]

 

[mymonsterbeetleisbroken]

Piccy:

[tylerdurden]

i have a set of hpi mt2 chrome wheels and the yokahama geo's fitted, i personaly think they are the best ones for the job and if you remove the step at the bottom of the door they dont rub that much! andy.

[billg4]

to run traxxas or RPM wheels use tg10 stub shafts because of the thick rim hub area.

 first is RPM revolvers, geolandars

2nd is imex all-t's and RPM Revolvers

3rd is duratrax and imex swamp dawgs no tg10 axle need on the duratrax wheel

[BigBison]

hi m8 what are tg 10 stub axle shafts off , got some traxxas stampede front wheels  cheers paul

[billg4]

http://www2.towerhobbies.com/cgi-bin/wti00...LXGM26&P=ML

[tamiya monkey]

hi there i have some hpi chrome rims fitted with geolanders but the front axle's are not long enough to get the nylocks on fully would these tg10 axles sort that out for me.

[billg4]

yes, exacly

thicker rims need the TG10 axles so threads stick through more for your wheel nuts

[BigBison]

hi m8 do you have the full part number for these tg 10 axles cheers paul

[tamiya monkey]

is it thee front or rear Tg10 axle that are needed, also i have some yokohoma geolanders and was woundering if to leave the foam insert's in or to take them out.

[billg4]

rear

http://www2.towerhobbies.com/cgi-bin/wti00...LXGM26&P=ML