Jump to content
Sign in to follow this  
Jedi Master

Srb Ball Race?

Recommended Posts

Hi all,

I'm looking to 'ball race' my Sand Scorcher but, of all the bearings that I have, none seem to be the right size for the gearbox. Are they a specific size and if so, can anyone tell me where to get them? I'm about to dremel the gear case so that I can fit a 'hotter' can, but dare not do this whilst the brass bearings remain. :D

Share this post


Link to post
Share on other sites

The SRB (Sand Scorcher etc.) run entirely on 1150 bearings.

11mm outer dia, 5mm thru hole, 4mm long.

A lot of the current Tamiya range still use this bearing, you shouldn't have any trouble finding them at a good hobby store.

If you use it, search eBay for 'Tamiya 1150' - 50p - 75p a bearing isn't unreasonable

Share this post


Link to post
Share on other sites
The SRB (Sand Scorcher etc.) run entirely on 1150 bearings.

11mm outer dia, 5mm thru hole, 4mm long.

A lot of the current Tamiya range still use this bearing, you shouldn't have any trouble finding them at a good hobby store.

If you use it, search eBay for 'Tamiya 1150' - 50p - 75p a bearing isn't unreasonable

Much appreciated. :D

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×
×
  • Create New...