mongoose1983 3335 Posted May 29, 2008 Hey Y'All,I grew tired of the depressing High-Lift front bumper and now want to make custom aluminium parts to hold the Bruiser/Mounty white front bumper. Is there anybody there to help me with the measurements of the space between the holes? This is for the front bumper only.Thanks in advance! Share this post Link to post Share on other sites
KEV THE REV 2319 Posted May 29, 2008 Hey Y'All, I grew tired of the depressing High-Lift front bumper and now want to make custom aluminium parts to hold the Bruiser/Mounty white front bumper. Is there anybody there to help me with the measurements of the space between the holes? This is for the front bumper only. Thanks in advance! EB -- Just measured an old one and it is 75.5mm centre to centre on the width and 12mm c/c on the hights Share this post Link to post Share on other sites
mongoose1983 3335 Posted May 29, 2008 Thank you so much, KEV! The info it's very appreciated. BTW, you mention an old one. Is it a spare one, cause I'll start searching for one from now on... Share this post Link to post Share on other sites
KEV THE REV 2319 Posted May 29, 2008 Thank you so much, KEV! The info it's very appreciated. BTW, you mention an old one. Is it a spare one, cause I'll start searching for one from now on... Best regards, EB -- Hi EB , when i say 'an old one', its used but still needed - but it could be for sale as i might use an aluminium one as used on my Bruiser Share this post Link to post Share on other sites