Cragus 0 Posted February 14, 2009 i wish to get rid of the plastic trailing arms, does anybody know where to buy these from? and what size? do i measure ball to ball or is it bottom of the thread, i really have no idea and really could do with some advice Share this post Link to post Share on other sites
53HRA 555 Posted February 14, 2009 Wow you must read my mind mate,i was going to make a topic about this just now because im after the same info as well Share this post Link to post Share on other sites
Cragus 0 Posted February 14, 2009 Wow you must read my mind mate,i was going to make a topic about this just now because im after the same info as well Ha Ha well i find it all very confusing! i dont know if other users are using them from other rc or what, i have looked on ebay and rc4wd but none of it makes sence!! Share this post Link to post Share on other sites
igbandy 34 Posted February 14, 2009 I will have a measure later on today as to how long the links are on my XC`s that I made. I used M4 all thread and some Traxxas rod ends. Share this post Link to post Share on other sites
gt6++ 29 Posted February 14, 2009 This thread may be of help. I think there used to be pictures but then seem to be gone. Share this post Link to post Share on other sites
Cragus 0 Posted February 14, 2009 i found this link and this is just what i want, i see the guy is using tlt shocks so that gives me a place to start!! heres the link http://www.scale4x4rc.org/forums/showthread.php?t=474 Share this post Link to post Share on other sites
Cragus 0 Posted February 14, 2009 IN THE PAST SOMEBODY HAS USED TRAXXAS STEERING TIE RODS, SO HOPE THIS HELP US OUT!!! Share this post Link to post Share on other sites
igbandy 34 Posted February 14, 2009 Now then, I have had a measure up of my CC`s and I have come up with the following measurements If you use Traxxas #5525 rod ends you will need 2 pieces of M4x65 threaded bar. If you use Traxxas #5347 rod ends you will need 2 pieces of M4x70 threaded bar. Take a look here for my CC lower links. And a couple of photo`s if you dont click the above link Share this post Link to post Share on other sites
tpsolid 24 Posted February 17, 2009 I found the traxas rods too long for my build so I used threaded rod + alum hosing and got some traxxxas ball ends. let me see if i can dig up some pics. Share this post Link to post Share on other sites