Help - Esc Radio Wiring Problem

[ScottyNI 0]

OKies,

just built up my m02L chassis and fired in standard can motor and an mtronics eco27 esc...

all connectors have been replaced wi upgraded ones, but just fired it up and esc seems noisy (is that normal)

also when i press to go forward its going in reverse? when i reverse the channel switch on the controller it does go forward but wi no where near the same power as what it was doing in reverse?

what have i made a mess of?

also a set button on the esc? wats this do?

[Mulsanne 0]

Sounds like the motor wires just need swapping round. The reason it's slow might be because the ESC has a low power reverse, but because the motor wires are the wrong way it's using reverse power to go forward. If you get what I mean.

[Blacque Jacque 4]

When you say "noisy" do you mean it whines ? If so, yes, that's normal.

Yes, I think Mulsanne is right about the motor wires.

[ScottyNI 0]

cheers guys... i'll give it a go ere, my new solderin irons gettin well tested lol...

[ScottyNI 0]

Yes... thats cured it