JayZ2000 0 Posted September 2, 2010 I have been bouncing around ideas for new wheels for my Grasshopper Shelby Mustang project. I bought a set of QDs off of eBay, and the fronts file like a glove. The rear are obviously not made for this application. HPI has some Rims that are close, and I may just get them to make a a roadable car. Today however I noticed that the front wheels of the F104 chassis look like they will fit on GH uprights, the bearings being 1050, instead of the 1150 of the GH. Has anyone tried this? Are the rears a 12mm hex format? Share this post Link to post Share on other sites
DCLXVI 3 Posted September 3, 2010 I did this with Group C fronts and rears, the rears (on the Grp C and it seems on the F103) are 14mm wich you can get from Traxxas and the front's where straight fits Share this post Link to post Share on other sites
JayZ2000 0 Posted September 3, 2010 I did this with Group C fronts and rears, the rears (on the Grp C and it seems on the F103) are 14mm wich you can get from Traxxas and the front's where straight fits Thanks - I think I'll pick up a set. Share this post Link to post Share on other sites