Porsche 934 RSR 49400 Hop-Ups

[Bjoern 0]

Hi,

I would like to build a Porsche 934 RSR 49400 with all Hop-Ups available. I found the following parts. Which are missing?

- 49425 - Tamiya RC TA05 Chassis Alum Aluminum Diff Joint - Blue

- 53644 - Aluminum Stabilizer End Blue

- 53875 - RC TA05 Lightweight Aluminum Servo Stay

- OP 952 - Porsche 934 Center One-Way Set

- 53884 - RC TA05 Carbon Battery Plate Set

- 53842 - Stabilizer Set (F & R)

- 49322 - 6mm Aluminum End Cap for Body Mount Blue

- 53909 - LED Light Unit

Thanks.

Regards

Bjoern

[qatmix 449]

- 53875 - RC TA05 Lightweight Aluminum Servo Stay will not fit, you will need the ones from the TBEVO4 or TRF415msx

Hi,

I would like to build a Porsche 934 RSR 49400 with all Hop-Ups available. I found the following parts. Which are missing?

- 49425 - Tamiya RC TA05 Chassis Alum Aluminum Diff Joint - Blue

- 53644 - Aluminum Stabilizer End Blue

- 53875 - RC TA05 Lightweight Aluminum Servo Stay

- OP 952 - Porsche 934 Center One-Way Set

- 53884 - RC TA05 Carbon Battery Plate Set

- 53842 - Stabilizer Set (F & R)

- 49322 - 6mm Aluminum End Cap for Body Mount Blue

- 53909 - LED Light Unit

Thanks.

Regards

Bjoern

[yamita 0]

If you're going to do any driving, you might want to get a 'direct coupling' for the front diff and ditch the center one way. If you want a shelfer, might as well go for the front one way to match the center one way. Since the chassis uses earlier reversible suspension, bearing spacers will make the tiny axle bearings last a bit longer. Alloy spring retainers are 1mm lower and you can achieve lower ride height with normal long springs. Tamiya also makes carbon bumper brace to replace the stock plastic one.

Since it's a pseudo race chassis, there are many more hopups, like titanium axles, low friction damper v parts, Ti screws, Ti turnbuckles. etc.

Tamiya (#53877) - Tamiya TA05 Front Spool Diff Set

Tamiya (#53891) - Tamiya Bearing Spacer for Reversible Suspension

Tamiya (#49311) - Tamiya TRF Damper Aluminum Retainer

RC Carbon Bumper Support

Item #54089

[qatmix 449]

I have a TA05MS which is retired now due to my 417... can you buy the parts to convert it to a 934? Ive seen the shell and wheels I just need the belts and chassis plates

[yamita 0]

you will need lower, upper decks and the front belt. you will also need narrower suspension blocks for offset wheels.