tb evolution 4

[owsey15 0]

hi there was just wondering if a tamiya 416 solid axle would fit in my evolution 4 as i want the diff locked and mine is broken.

i have the link for the axle here ebay item : Item number: 200664855497

cheers john

[qatmix 794]

hi there was just wondering if a tamiya 416 solid axle would fit in my evolution 4 as i want the diff locked and mine is broken.

i have the link for the axle here ebay item : Item number: 200664855497

cheers john

I'm pretty sure it wont. The Ta05 one might be a better fit. Can you measure the gap between the inside of the front bulkheads? Then I can give you a better answer Also I dont know if you can fir the bevel pulley on a ta05 or TRF spool

[owsey15 0]

hi mate 2.5cm on the inside of the bulkheads , thanks for the help.

cheers john

[qatmix 794]

hi mate 2.5cm on the inside of the bulkheads , thanks for the help.

cheers john

Right you want this direct spool axle Tamiya 54125 OP1125 TB03 Direct Coupling (spool)

Officially its a spool for the TB03D (or stock TB03) but it should fit the tbevo4

Tamiya 49359 Front Direct Coupling Spool (TB Evo IV) was the original part but was impossible to get even when the 04 was out.

You might still have to fit a tbevo 4 one way bevel pulley on the spool as I think the later ones had more teeth. You might also have to shim it a little, although it probably will fit straight in.

Hope this helps.

[WillyChang 1814]

belt-drive cars won't offer much usable parts, TBeIV has its own spool part:-

HTF but today the TB03D item is cheaper & easier to get:-

http://i153.photobucket.com/albums/s232/ko...o/DSC05602s.jpg

(its not as finely machined though )

ring gear that comes in bag is for evo5/TB03

you will need to switch for evoIV item

after which it drops in fine & u shim it sweetly as per any other diff