Monster Beetle Thorp 4509 (HELP)

[Billy01]

I need help, I'm looking for one long joint shaft (Thorp 4509) to complete my rear end. Does anyone know what other vehicles would work other the Blackfoot, Mud Blaster, Frog... I went on Ebay and tried to search and the only thing that came up was the Kyosho Big Brut and Double Dare. Any help please.

[tamiya monkey]

I need help, I'm looking for one long joint shaft (Thorp 4509) to complete my rear end. Does anyone know what other vehicles would work other the Blackfoot, Mud Blaster, Frog... I went on Ebay and tried to search and the only thing that came up was the Kyosho Big Brut and Double Dare. Any help please.

Would a tl01 or newer re-re brat shaft fit, they look the same.

[Billy01]

Would a tl01 or newer re-re brat shaft fit, they look the same.

Don't know...maybe

[Billy01]

Would a tl01 or newer re-re brat shaft fit, they look the same.

the tl01 looks to be to short, the re-re brat looks like it might, but also looks like a different type of end...

[OldSchoolRunner]

You are going to have to be patient! Ebay is your best best. Can be pretty pricy but you never know you might get lucky. I have two sets that I found 6-7 years ago. Now they are getting fewer and fewer.

OSR

[Billy01]

You are going to have to be patient! Ebay is your best best. Can be pretty pricy but you never know you might get lucky. I have two sets that I found 6-7 years ago. Now they are getting fewer and fewer.

OSR

I know, it's hard to wait when your trying to finish a project.

[OldSchoolRunner]

I know, it's hard to wait when your trying to finish a project.

I understand fully!

OSR

[Billy01]

I understand fully!

OSR

Also, OldSchoolRunner, I never ended up getting new bearings for the Thorp, I found (1) 1/16 that I was looking for...(from older post).

At least on the other side, I put the stock gears in and runs pretty good for now...knowing I have a Thorp "almost" ready to go in....it was just something that I could not afford way back when....

[OldSchoolRunner]

Also, OldSchoolRunner, I never ended up getting new bearings for the Thorp, I found (1) 1/16 that I was looking for...(from older post).

At least on the other side, I put the stock gears in and runs pretty good for now...knowing I have a Thorp "almost" ready to go in....it was just something that I could not afford way back when....

I get your point. Look no promises now. But let me have a look in the basement workshop. I might have one? Maybe? Maybe?

OSR

[Billy01]

I get your point. Look no promises now. But let me have a look in the basement workshop. I might have one? Maybe? Maybe?

OSR

Thanks, wasn't asking, but thanks

[Billy01]

I got got an extra set of brand new dogbones (Thorp 4510) with a small Thorp decal NIP. I am willing to trade someone who has any (Thorp 4509) long shafts for the MB, BF, Mud Blaster. I just really need one.

[Billy01]

OSR, I waited and you were right...got a brand new sent off of eBay, the price was a little high but.....