Jump to content

Recommended Posts

Hi everyone, just a quick question. Can you lengthen the wire from the esc that goes to the motor? The esc i have has leads that are 75mm & they dont reach the motor :( they only need to be 30- 40mm longer is this ok? I'm only asking because someone said the length was gauged for volt drop - bla-bla & it wasn't possible.

Thanks :wacko:

Share this post


Link to post
Share on other sites

You can lengthen the wires, just use the same gauge. The longer the wire the more resistance it will have so keep things as short as possible. For a sensorless brushless setup keep the lengths the same since the ESC will rely on the feedback through the wire to detect the rotor position.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...