elsworth 0 Posted September 22, 2012 well it was working forward and back just fine and after i may be pressed a button or something it only works forward. ive tried the settings on the manual that i down loaded but still only works in reverse . can any through some light on this and please tell me in layman terms how to correct it. many thanks Share this post Link to post Share on other sites
atf300 28 Posted September 23, 2012 i think those ansmann escs are mtroniks viper or similar, so check the instructions for those on how to programm them. easiest way to find out which it is ,is to look at the wire locations. its either a viper or a tio probably Share this post Link to post Share on other sites