Foxaddict 3 Posted March 15, 2014 I hope someone can help. After much deliberation I took the plunge and bought a used topforce. I'm going to do a full strip and rebuild, and run it with a brushless set up and 2s lipo. Has anyone got any suggestions for the battery tray fittings to get the lipo in. my current lipo dimensions are 136x45x22mm, so it's just a smidgen too long for the standard battery end bars. Many thanks Share this post Link to post Share on other sites
waterbok 1282 Posted March 15, 2014 Dont use the standard setup, make some diy Velcro straps to secure the lipo. Share this post Link to post Share on other sites
Foxaddict 3 Posted March 19, 2014 Thanks, I'll give it a go Share this post Link to post Share on other sites
Adamcurrie 34 Posted March 20, 2014 Here's what I've done so far Not perfect yet, I think the Velcro idea may be better. Share what you end up doing Share this post Link to post Share on other sites
ddaenen1 278 Posted March 20, 2014 My lipo fits perfectly in the exisiting brackets. I have a 2S 7.4v 25C stickpack from RCPlus. 1 Share this post Link to post Share on other sites
MAD RACER 566 Posted March 20, 2014 I made some battery straps and used saddle packs BUT I think you can fit a shorty up the guts which would be better again as it keeps the weight on the centreline.. Share this post Link to post Share on other sites
ddaenen1 278 Posted March 21, 2014 Send a pic OK, will do tonight. Share this post Link to post Share on other sites