beetleman 51 Posted July 4, 2014 I have a Spectrum DX4C and an SR201 receiver. After binding them together, motor goes to full throttle when trigger is at neutral. When I push the trigger all the way to reverse, it's as if I let go of the throttle and the motor stops. I tried reversing the throttle channel but then it works the other way around - motor still goes to full throttle when trigger is at neutral, and stops at trigger full throttle! The ESC is forward only type. Does that have anything to do with it? Or is the receiver faulty? (brand new receiver). The trasmitter has been boundto another receiver (on a different model profile) which works fine. Please help. Thanks Share this post Link to post Share on other sites
InsaneJim69 1584 Posted July 4, 2014 Sounds like a case of setting the ESC up for the nuetral and maximum throw points. What ESC are you using? As usually goinf through the ESC setup as per the instructions for that specific type of ESC will solve the issue instantly. James Share this post Link to post Share on other sites
Wobbleboxer 10 Posted July 4, 2014 Is the trim on the transmitter set to the midpoint? It could be trim is full on. Share this post Link to post Share on other sites
WillyChang 1814 Posted July 4, 2014 Rebind with TX at neutral; your failsafe is set to max throttle. Share this post Link to post Share on other sites
