Gravel Wolf 6 Posted June 28, 2015 I can see a few people have put regular buggy wheels on the Mad Bull, but the axles are too long to take regular wheels. I know some have swapped them over for the short ones but I have also seen spacers mentioned. I would like to be able to interchange wheels on demand and having to swap the axles out would not be practical. Does anyone know what kind of spacer is needed to make the regular buggy wheels a snug fit on the front? Many thanks! Share this post Link to post Share on other sites
KEV THE REV 2319 Posted June 28, 2015 Not used any other wheels on a Mad Bull myself, but I would think the old 1150 plastic wheel bearings that nobody uses would suffice and use washers to fine adjust the width you need Share this post Link to post Share on other sites
Gravel Wolf 6 Posted June 28, 2015 That's a very simple but elegant solution, will give it a try Thanks! Share this post Link to post Share on other sites