Associated RC10 parts/project lot

[markbt73]

So over the past few years, I have bought 2 huge lots of RC10 cars and parts, and restored and sold most of them. This is what's left.

There's enough parts there to build one complete "Team Car" style buggy for sure, and nearly enough for either an RC10T or a second buggy. Two tubs, one complete gearbox (Stealth) and 3 partial gearboxes, two buggy nose plates and one truck nose plate/front clip, several sets of plastic suspension parts, several sets of wheels and tires, shocks galore, shock towers, CVDs and axles, turnbuckles, hadrware...

Most of it is used, and some is VERY used. But it's still useable. And if you can coax a nice runner or two out of this lot, you'll have achieved Grand Master RC10 Guru status.

I'll even throw in an SAE hex wrench set, for those of you outside the USA who can't get the right tools for these easily.

$100 or so? or trade for a restorable Fox roller. I need a new challenge.

[swapto]

Do the 2 big monster truck wheels and the 2 white dish wheels (to the left of the monster wheels) all have 12mm hex?

[markbt73]

No, none of the old RC10s used a 12mm hex. The rears are for a 1/4" axle with a cross pin, and the fronts take a 3/8"x3/16" bearing.

Edit: Also, for the record, before anyone asks, I am not going to sell bits and pieces out of this lot. It's all or nothing.