davepettigrew 0 Posted April 16, 2016 I have a cpr160 unit that has no range any suggestions Share this post Link to post Share on other sites
94eg! 834 Posted April 18, 2016 possibly a damaged crystal or the wrong band or brand crystal. The Tamiya crystal sets are 27mhz AM Futaba. Also possibly a damaged antenna connection inside. Share this post Link to post Share on other sites
davepettigrew 0 Posted April 19, 2016 27mhz that could be the problem all I have is 75 mhz Share this post Link to post Share on other sites
94eg! 834 Posted April 20, 2016 That would definitely be the problem. Share this post Link to post Share on other sites
Tamiya Era 778 Posted April 22, 2016 I made a thread about same issue i had before, as i was suffering from short range and after analysis, it turned out to be at bottom of the antenna has small cut whcih was causing rattle disturbance and short range also, as mentioned before, check on the frequencies, Crystals and Antenna cheers Share this post Link to post Share on other sites
davepettigrew 0 Posted April 22, 2016 Success got a jr beat 2 alpina on 27mhz works flawlessly Share this post Link to post Share on other sites
salvine 125 Posted August 1, 2019 Just found this thread. Just received and never run TA02 from Buyee in Japan. Turns out it has a mint CPR 160 set with steering servo installed. I dug out an Old ADSPEC transmitter I had and BAM. Works perfectly. Mint vintage running gear. Share this post Link to post Share on other sites