pijje1 49 Posted February 5, 2017 Hi All After along time and help from a friend on here I have a Cr-01 Now I am looking at hot ups lol and electronics so far this is the list so far Tamiya #54048 - RC CR01 Strengthened Wheel - Axle (2 pcs) x2 Tamiya #54087 - RC CR01 Alum Side Frame Tamiya #54105 - RC CR01 Aluminum Skid Plate - For CR-01 Chassis Tamiya #54112 - RC CR01 85mm Steel Prop Shaft - Carbon - For CR-01 Chassis Tamiya #54113 - RC CR01 95mm Steel Prop Shaft - Carbon - For CR-01 Chassis Tamiya #54206 - RC CR01 Turnbuckle Tie-Rod Set - For CR-01 Chassis x2 Tamiya #54109 - RC CR01 Aluminum Damper Set - For CR-01 Chassis Tamiya (#54030) CR-01 Setting Stabilizer Set x2 Tamiya (#54047) CR-01 Aluminum Servo Bed x2 Tamiya (#54084) CR-01 Barrel Spring Set x2 Tamiya (#54100) Toyota Land Cruiser 40 Plated Grille Tamiya (#54102) CR-01 Reinforced King Pin x2 Tamiya (#54103) CR-01 Heat Sink Motor Plate Tamiya (#54106) CR-01 Bent Lower Arm (Front) Tamiya (#54107) CR-01 Bent Lower Arm (Rear) Tamiya (#54111) CR-01 Carbon Mechanism Deck Tamiya (#53569) Clamp Type Alum Wheel Hub (6MM Thick) 4pcs Tamiya (#51000) Servo Saver High Torque Type (black) As for Electrics thinking mtroniks tio rock crawler esc Etronix ES092 Digital STD Waterproof Metal Geared Servo x2 Tamiya (#54114) CR-Tuned Motor (35T) what do people think ?? or have other ideas or suggestions cheers paul 1 Share this post Link to post Share on other sites
pijje1 49 Posted February 8, 2017 Hi all Any help or suggestions on the hot up front Before I order Cheers Paul Share this post Link to post Share on other sites
pijje1 49 Posted March 9, 2017 Hi all I am building a cr-01 with 4ws and looking for some thoughts on servo arms I have 25t high torque servo the arms I bought are to long and hit the lower steering link the arms I bought are show below and now not sure what to look for hope to hear your advice Paul Share this post Link to post Share on other sites
pijje1 49 Posted March 10, 2017 Anyone out there that can help ? Share this post Link to post Share on other sites
Darat76 265 Posted March 10, 2017 would spacing the servo a fraction to clear the links be a possible solution that could allow the use of those servo horns? or perhaps servo's with a shorter height between the mount face tabs and the top of the output shaft? I have no knowledge of the servo and steering setup on the CR-01, but have noticed some tamiya kits require small changes to allow proper clearance for the steering servo to clear everything, and that many race kits have spacers to get the steering servo in the correct spot for clean steering action. Share this post Link to post Share on other sites
pijje1 49 Posted March 16, 2017 Hi all this is my part assembled cr-01 think she is looking fab so far would like to thank people on here for the help and advice and the inspiration to build one cheers Paul Share this post Link to post Share on other sites